Tray Manual

In our continuing attempt to supply our customers with as much information as possible about our equipment, here is our 2nd installment of our Machine Service Manual.

Table of Contents

• 0.0 – TABLE OF CONTENTS
• 1.0 – INTRODUCTION
• 2.0 – SAFETY FEATURES
• 3.0 – INSTALLATION
• 4.0 – OPERATION
• 5.0 – SET-UP AND ADJUSTMENTS
• 5.1 – TRAY SET-UP
• 5.2 – TRAY KWIK CHANGE SETUP & ADJUSTMENT
• 5.3 – CABLE ADJUSTMENT
• 5.4 – CORNER FLANGE SEAL (CFS) SET-UP
• 5.5 – CORNER FLANGE SEAL (CFS) w/ MINOR FLAP KICKERS
• 5.6 – NORDSON ECLIPSE SETUP
• 6.0 – TROUBLESHOOTING
• 7.0 – MAINTENANCE
• 7.1 – DAILY LUBRICATION
• 7.2 – DAILY CHECKLIST
• 7.3 – PLEMONS GLUE PUMP
• 7.4 – NORDSON ECLIPSE MAINTENANCE
• 8.0 – PARTS LISTS & ILLUSTRATIONS
• SECTION “A" — VACUUM FEED ATTACHMENT —
• VACUUM MOTOR FILTERS SERVICE

Tray Options

• VFD – VARIABLE FREQUENCY DRIVE
• 440 TRANSFORMER MOUNT
• WARNER CLUTCH – BRAKE
• AUTOMATIC LIDDING ATTACHMENT
• DOUBLE FEED ROLLER
• DOUBLE FEED ROLLER – DOUBLE PROGRAMMING
• EXTENDED BODY HOPPER
• LOW LEVEL HOPPER SENSORS
• KWIK CHANGE MANDREL CARRIAGE ASSEMBLY
• COMPRESSION ASSEMBLY – UNDER MINIMUM HEIGHT
• OUTSIDE MINOR FLAP
• REVERSE FLAP GLUING
• ROTATING MINOR FLAP PLOW ASSEMBLY
• SWIVEL CASTERS
• CABLE PROGRAMMING
• ROLL-OVER LOCKING (ROL) ASSEMBLY
• TRAY KWIK CHANGE ASSEMBLY
• NORDSON GLUE SYSTEM
• CORNER FLANGE SEAL ATTACHMENT 4" OR LESS
• CORNER FLANGE SEAL ATTACHMENT 3" TO 6"
• CORNER FLANGE SEAL ATTACHMENT 4" to 8"
• CORNER FLANGE SEAL ATTACHMENT 4" to 10"
• CORNER FLANGE SEAL ATTACHMENT 6" to 11"